ADs & Safety Bulletins
ADs & Safety Bulletins

FAA proposes updated EC155 window-jettison AD to cover tinted windows

A proposed FAA AD would supersede AD 2025-24-01 for all Airbus Helicopters EC 155 B and B1 helicopters, keeping the jettisonable window and seal replacement and adding steps for aircraft with tinted windows.

The FAA has proposed an airworthiness directive (Docket No. FAA-2026-13814; Project Identifier MCAI-2026-00037-R) that would supersede AD 2025-24-01 for all Airbus Helicopters Model EC 155 B and EC 155 B1 helicopters. It was published in the Federal Register on November 16, 2026. Comments are due by December 31, 2026.

The problem

The original issue is that the force needed to jettison the windows can be higher than the maximum allowed. If a window cannot be pushed out in an emergency, occupants may have less ability to evacuate and could be hurt. AD 2025-24-01 already requires replacing the jettisonable windows and seals on the left and right sliding doors and fixed panels and adding new labels.

After that AD was issued, the manufacturer found that its service information had no procedure for helicopters with tinted windows installed through Airbus Helicopters mod OP52C38. EASA replaced its earlier directive with EASA AD 2026-0011, dated January 15, 2026, to cover those aircraft.

Proposed required actions

Operators would follow the actions and compliance times in EASA AD 2026-0011. That means the same window, seal and label work as before, plus new steps for tinted-window helicopters. U.S. differences: use the FAA AD’s effective date in place of EASA’s; use January 12, 2026 (the effective date of AD 2025-24-01) where the EASA AD refers to September 18, 2024; and use hours time-in-service in place of flight hours. Reporting to the manufacturer would not be required.

Cost

The FAA estimates the AD would affect 16 U.S.-registered helicopters. Replacing the windows and seals and installing labels is estimated at 24 work-hours ($2,040) plus up to $53,553 in parts, for up to $55,593 per helicopter. With tinted windows, parts run up to $60,000, for up to $62,040 per helicopter.

GO DEEPER

Go straight to the source.

Rotor Brief provides short original summaries. Read the original publication for full context.

Read the original article

News summaries are not maintenance instructions or an official airworthiness determination. Consult the applicable authority and current approved documents.