ADs & Safety Bulletins
ADs & Safety Bulletins

FAA proposes AD on BK 117 air-conditioning duct that can chafe tail rotor shaft

A proposed FAA AD for MBB-BK 117 C-1 and C-2 helicopters with a certain Air Comm air-conditioning STC would require repeat checks of the tail rotor drive shaft and condenser duct after corroded duct wire wore against the shaft.

The FAA has proposed a new airworthiness directive (Docket No. FAA-2026-13816; Project Identifier AD-2026-00521-R) for all Airbus Helicopters Deutschland GmbH Model MBB-BK 117 C-1 and MBB-BK 117 C-2 helicopters that have an Air Comm Corporation (ACC) air-conditioning system, part number EC145-7040-1, installed under STC SR00601DE. The notice of proposed rulemaking was published in the Federal Register on November 16, 2026. Comments are due by December 31, 2026.

The problem

The FAA received reports of heavy corrosion on the condenser inlet duct. The corrosion let the duct’s internal support wire helix break and poke out through the silicone shell, where it rubbed the tail rotor drive shaft. Left alone, the FAA says, this could lead to tail rotor drive shaft failure and loss of control.

Proposed required actions

Within 7 days after the AD takes effect, and then at intervals of no more than 50 hours time-in-service or 3 months, whichever comes first:

  • Inspect the tail rotor drive shaft below the ACC condenser air inlet duct for protruding wire or wear. If either is found, replace the shaft before further flight using an FAA-, EASA- or Airbus Helicopters DOA-approved method.
  • Inspect the outside of the duct for broken helix wire or bulging over the drive shaft, and squeeze it by hand to make sure it springs back to round.
  • Borescope the inside of the duct for corroded wire or silicone lining that is separating, bubbling or peeling.

Any failed duct check means replacing the duct with a new, zero-hour, never-installed ACC duct before further flight. Special flight permits would not be allowed.

Cost

The FAA estimates the AD would affect 54 U.S.-registered helicopters. Each inspection is estimated at 1 work-hour ($85), and the borescope inspection at another $85. If needed, a replacement duct is estimated at $385 and a replacement tail rotor drive shaft at $11,013 per helicopter.

GO DEEPER

Go straight to the source.

Rotor Brief provides short original summaries. Read the original publication for full context.

Read the original article

News summaries are not maintenance instructions or an official airworthiness determination. Consult the applicable authority and current approved documents.